Hollyview APP Connection

Overview: This article describes the procedure of APP connection. 

If you doubt whether the App feature is available for your model, please refer to the below chart.

Model	Support The Number Of RX	Support The Number Of Mobile Devices	Remarks
Mars 300 Pro	1	1
Mars 400	Up To 2	Up To 4	0 RX Add 4 APP Monitor 1 RX Add 2 APP Monitor 2 RX Add 0 APP Monitor
Mars 400s	Up To 2	Up To 4
Mars 400s Pro	Up To 2	Up To 4
Mars X	0	Up to 3	Only Support APP Monitor

NOTE:

•      Turn off the data cellular under phone settings for the 1st connection.
•     Allow the App to access the Precise location.

OPERATIONS:

•     Turn on the TX and remember the SSID number
•     Select the Wi-Fi named "HLD_SSID" in the Wi-Fi settings of your phone
•     Click the Wi-Fi to connect with the default password: 12345678
•     Open the Hollyview App, then click "connect."

Use the cellular data and Wi-Fi at the same time:

 Please click the "cellular" in settings, slide down to the bottom, Finally close the Wi-Fi Assist.