When mounting multiple Arocam C2, How to separate control by one remote-control? Hollyland Tech August 24, 2022 07:50 Updated OVERVIEWS: The default camera control address is 1, so when multiple cameras are in the same place, they will be controlled at the same time. The article below show you how to set the camera to other address, so you can control separately. Step 1: Turn on the camera which you would like to set the address and turn off other cameras. Step 2: The remote control select 【1】 in the 【Camera Select】 on the top of the remote control. Step 3: Then click 【*】+【#】+【F1/F2/F3/F4】 in turns, the camera address will turn to 1/2/3/4 E.g: Set the camera to address 2. Step 4: After changing the address, you need to select the corresponding address in 【Camera Select】 to control the corresponding camera. Tip: Follow the steps above to modify the address of other camera. Related articles How to use 【PRESET】 function to set the camera preset position. How to set Arocam C2 to landscape when live streaming? Serial port cannot control How to enter the web setting page? How to add Arocam C2 to Live software? Comments 0 comments Article is closed for comments.