How to upgrade Lark 150 Firmware? Hollyland Tech March 02, 2023 03:09 Updated 1. Preparation 1.1 One laptop with Windows system 1.2 One USB-A to USB Type-C cable 1.3 Put all TX and RX into charge box 2. Firmware Upgrade Note There is the risk for upgrade,please don't upgrade the Lark 150 when there isn't any problem If upgrade failed,please trying to downgrade to one old version If upgrade successful, but one of the TX can not receive the audio, then pls trying to upgade the TX separately, always put the TX into the right slot of the charge box for upgrade If the original firmware version lower than 1.0.8.8(Long-press the mute button of RX to check the firmware version when all RX, TX is in the box , long-press again to check the detail version of the TX and RX), pls upgrade to 1.0.8.8 first, then upgrade to the others version Please don't take out the TX,RX or USB cable when upgrading. Steps 2.1 Download the related files from the download link and unzip it on the desktop 2.2 Install the driver showing as below: 2.3 Connect the charge box via USB cable and open and run the "6901_upgrader.exe" application 2.4 Click "Refresh" and wait for the device connected, and then click "upgrade" for upgrading 2.5 wait for the upgrade till the program page showing upgrade successful Video Tutorial: Related articles How to connect the Lark150 to the smartphone and audio devices? How to Pair the Transmitter and Receiver? How to use the 4 Record Modes? How to set them up when multiple sets of lark 150 are used at the same place? How to contact Hollyland Support Team? Comments 0 comments Article is closed for comments.